2 x 6dBi 2.4GHz 5GHz Dual Band WiFi RP-SMA Male Antenna+2 x 35CM RP-SMA IPEX MHF4 Pigtail Cable for M.2 NGFF WiFi WLAN Card

Works well, decent quality

Pretty decent signal, not perfect but no complaints. The adapter or device that you have these connected to has more of a significance on the performance of what you are receiving in terms of signal strength and throughput/speed. The converter adapter pieces/cables included make this antenna combo a good package deal. The antennas screwed in smoothly and with a firm lock (not loose or wiggly) I used mines as replacement antennas, just to see if I can squeeze out another megabit or 10, I'm not sure if I did, but does it really matter. Nowadays everyone has at least 200 Mbps internet

I haven't installed these connectors before, but the original connector seemed to go back on a lot easier than these would go on. I am not sure they were a perfect fit. It took a good deal of time to get them on. Now they are on it is working well and I have good WiFi reception.

If your like me, and you accidently cut the wire connecting your 2x2 Dual Band Wi-Fi antenna for your PC, then this is a MUST Buy! The signal is strong even when the PC is behind a wall blocks by multiple obstacles! It's easy to screw on and does not need the wire to install IF the WIFI 5/6 ports are installed on the motherboard. Overall, this definitely does the job! The only thing that bothers me is that you can't really position the antenna a little off from up-right, otherwise it will try to snap back into the 90 degree up right position. It can rotate in all directions and pulls in all the Wi-Fi signals easily! Worth the price and should be recommended as the top Dual Band Wi-Fi antenna on the market! Also! There are NO cuts or down connections when connecting with Wi-Fi or Bluetooth! So worth it! Thank You! 9/21/2020

Purchased this because the AsRock B550 Pro 4 m.2 slot looked a little far aware for a typical antenna cable. Worked as expected. Antennas can get loose from the Mobo when adjusted, but that's just the nature of this design. The pinhole connectors are super tiny and a bit tough to plug in (phones use these for their antennas as well). I'd recommend using the cable to line it up and using a spudger or fingernail to plug it in. Personally, a simple USB wifi antenna(s) is a lot easier and can be easily moved between computers, and a 2 antenna one is around the same price as this and a m.2 wifi card. Unless you really need one extra USB port or are using this for a tiny computer where every mm around the case matters, I'd go that route.

I bought this to add WiFi to my Dell Optiplex 7070 micro system. The adapters that connect to the case were easy to install, however the end that connects to the wifi card are terrible. I could not get them to remain connected. The force of the cables were enough to unplug them. I did solve this by holding them in place and added a dot of hot-melt glue over the connections. I though all was well, but then found out that in my case, the antenna's wouldn't work as their large connector size prevented both of them from being connected at the same time (very small PC has limited space between the connectors). All was not lost as I have a desktop with very slim connectors and I just swapped them. Would have been annoying to need to return this because of fitment issues.

I used this kit to repair a PCI’e Wi-Fi card. An original lead wite broke & I replaced both with those included in this kit. After I installed it, my computer Wi-Fi capability was restored & it’s working fine now.

Work but over pricwd