10" Wide LED Wraparound

Expensive when compared to others, but it was a simple install and they are very bright.

These lights are very bright and put off good light coverage in my room.I’ll buy more of these for my shop and camp.Great product.

Only thing that could be better is if the slots to attach the fixture to an electrical box went 360*. Also a channel to cover the wires would be nice. But very bright and reasonably priced.

I purchased these lights for my garage and I’m impressed so far. Most of the similar lights I found at 8500 lumens were much higher priced. I have a 20’x20’ garage and it is very bright.They are linkable, but hard wired. Many other lights like this have a plug in link for easy linking. So you’ll need a wire stripper if you want to link to others. But 4 lights was plenty for my garage.

Where to start? In short, poor packaging and not what description says ("wraparound"), but LOTS of light!ALL of the four fixtures in the package were damaged at the ends so the plastic cover would not come off. Had to be straightened by HAND. Fixtures are made from VERY flimsy sheet metal so DO NOT pound or hammer on them in any way. Straighten by clamping two wood blocks where the fix needs to be bent and then bend back into shape SLOWLY by hand. to prevent damage to paint. Make SURE the ends are bent open far enough, about one to two mm, to allow the plastic cover to be inserted with minimal force. On the inside, the wiring covers had all shaken loose during shipment because the screw holes were STRIPPED. Attach with bigger self-tapping screws to fix. MOUNTING: The LED strips go OVER the fixture attachment holes so these cannot be used to anchor the fix to the ceiling; depends on how far off from a right angle the mounting screws are in the electrical box. Just insert the screws in the box and hang the fixture from them and then screw them in ALMOST snug, but allow enough to rotate the fix to position. Then use OTHER screws to secure to ceiling. One code violation note; the knockout will require a grommet or a fitting otherwise the power wires will rub against the sharp edges of the hole. Considering the price of these fixtures they could have provided three two-cent plastic electrical bushings/grommets. Additionally, use WHITE tape and secure any loose wires to the inside top of the fix so the LEDs won't cast light on them. The knockouts at each end leak light, so cover then on the inside with opaque tape. ONE SERIOUS NOTE; these are NOT 'wraparound" fixtures as the description claims. A 'wraparound" fixture cast light down and out the sides to the ceiling; hence the light "wraps around". These cast all light downward and do NOT illuminate the ceiling. For some this might be OK, but I wanted to light up the kitchen ceiling. Should have got AntLux "Slim" fixtures, but would have to buy and try first! Now the important thing; these are very bright (do NOT look at them with cover off) and give off lots of light. Hence two stars and not one.UPDATE: After a year of normal use as kitchen ceiling light, one 18 inch long section of the LEDs in one of the fixtures has FAILED.

Excellent garage lights, installed 3 end to end.Really brightened my garage lighting, can see any items I dropped, screws, bolts.Only negative complaint - the way the lights are shipped, flimsy cardboard does not protect the lights in transit resulting in bends in the metal frames.

Great light! Only problem is the way the bezel is secured (or rather not secured). Bezel is held in place by sliding all the way over to one end. Problem is that over time bezel will creep to the opposite side and release. On 3 occasions had the bezel fall out of different fixtures and hit the floor.

UPDATE: Antlux has a very responsive customer service and they took my comments serious. They took care of my issue immediately. Upgraded from my initial 2 star review to 5.Had expected more from these lights. Arrived damaged in box which I unfortunately found out too late to return them. Cheaply made which easily results in a bend housing. Shade can be very hard to remove and install when the housing had warped a little. I don’t know if I will keep these as they look cheap. Probably just use them as a temporary lighting solution until I complete the redo of my garage. Would not recommend.