Bosch SP0F000049 Style Line 2" Electrical Water/Oil Temperature Gauge (Black Dial Face, Black Bezel)

Works as it should, easy install

I have bought three of these now for use in my offshore fishing boat. They are good quality and hold up well in a corrosive environment.

I installed this on an early 90's cummins that is installed in a 107 year old fishing boat. The installation was nice and easy, and it fit into the existing threaded port using one of the included adapters. The previous indicator was a cap-tube style sensor, and it had long since failed. Because of this, I needed to source a hot and a ground that was common with the engine block (harder than you might imagine on a 107 year old wooden fishing boat) but after that was handled, installation went just fine. You are only given 1 crimp connection in the kit, and it's for crimping onto the sensor wire at the engine side. You will need to provide your own ring crimps for the other connections. I can't say for sure that it is accurate, since I don't have a good way to verify, but even if it's a few degrees off, it's good enough for my needs. My only regret is that I got the black one... shoulda gone for something with a chrome bezel, but that's on me, not the manufacturer.

Reads correctly, easy to install. 4 stars because the bulb didn’t last but a week. Not a big deal but not perfect

Started with a very cheap wt gauge and was not accurate , returned it , searched for one with good reviews, this one seemed to match that and for a good value and a reputable name, even if it is made in China along with other low cost brands of gauges , and is accurate with in 5 deb of a infra red heat gun test for comparison

Gauge works well, quick delivery, good price. I installed in my 1978 motor home as a temp. gauge for my transmission. Instructions say not to install in T fitting in the line but a similar gauge from B&M transmission says that’s where to put it. I replaced the last bend into my radiator from the trans., cutting it off and routing the line into the side of the T fitting, the sender into one end and adapter fittings into the radiator on the other end. Solidly mounted and the fluid flows right by covering the sensor.

Nice looking, works well, great that it comes with an assortment of adaptors for the sensor

Insalled this in my S10 pickup that I had recently swapped a 350 into. I wired the gauge up and it seemed to be accurate, up until today when it just stopped working. The engine was over 180 degrees and my electric fans were running, gauge needle was stuck at 120. I troubleshooted it with a multimeter and had battery voltage at the positive terminal, ground and signal wires checked out good at 0 ohms and around 340 ohms through the sensor. I will be replacing this gauge with a different brand and adding Bosch to my blacklist.

Excelente producto

The temperature gauge in my 1993 Accord died so I decided to try out this gauge. Installation was straight forward. Being an electrical gauge I ran a simple wire through the door jam from the gauge to under the dash. Gauge worked properly for a few days then the gauge needle started to vibrate. I checked all of the connections which were a bit loose, tightened them up and the gauge was fine.

works great and accurate i put the green silicon cover on the bulb to make the light green wish they came with them but i had one so no worries

.

works good for now