Antrader 4 Pcs Forged Brass Ball Valve Mini Shut Off Switch, 1/4" Hose Barb x 1/4" Hose Barb, 180 Degree Operation Handle

I was tired of the plastic valves leaking. These are easy to turn and don’t leak.

This valve is Excellent, I had bought those cheap plastic cut-off valves and they are junk. These are all Brass including the ball. I just hooked it up to my lawn mower after the cheap plastic one literally came apart spilling gas all over. This one is smooth operating and does Not Leak. I really like the 180 degree handle so it can be turned off on two directions if it is up against some object like my gas tank it can be orientated to operate as you need it to. I have not tested for long, but It seems to be well made and the handle is perfectly long enough to open and close the valve and it operates so smoothly. I do believe now I have the right cut-off valve for my small engines. Going to replace the other one on the tiller soon. And YES I do recommend these for small gasoline engines. I like them very much.

Barbs run small used heat shrink tubing 3layers each side and then it fit like a glove. Ball valve shuts fuel off nicely no bypass detected Very easy to install Just make sure you have the right size clamps

Have not used them yet. They look much better than the cheap plastic ones that start leaking after a short time.

Works just as it is supposed to and good quality

Works well...but one out of the four received in the package was cracked. It is made out of brass? Brass shouldn't crack easily when there is nothing for it to be tightened with. You put a hose over it with a clamp. There is no thread on the brass for it to be tightened to make it crack. Looks like whoever tightened the barb piece over-tightened it to the point of cracking. This made me realize how fragile and thin this brass is. I used to for pumping gear oil into my vehicle. The other pieces work well but I didn't pay for three pieces. I am returning all four.

I got a set of 4 of these to put in my 4-tire-at-once inflation system I put together for my HMMWV and using the Maxi Trax air compressor. Make sure you make sure these are all good before you walk off though. 1 of the 4 leaked air as i turned the handle. I had to tighten up the outside nut on the valve and then all was good. Check out the video I made on my channel. I replaced the check valves with these so that way all 4 tires balance themselves out with each other and end up with the exact same air pressure all the way around.

A little cheap on the lever part, but seems they seal and will work as intended.