3D Printer PLA Filament 1.75, JAYO Grey PLA Filament 1.75mm, Dimensional Accuracy +/- 0.02 mm, 1KG Spool, PLA Grey

Great Product/ Great Support.

I noticed these lines 20 hours into my print… not sure what to make of it. I’m not sure if it’s inconsistency in the color or what.. I’m not too concerned, I’ll likely spray paint this matte black when I’m done with it so I won’t see it, but others might want to be awareI’m using a voxelab aquila 3D printer.Temp settings are 200° nozzle 70° bed I used to do 60° but I like 70° better..16mm line spacing for my mask print

I've had really great results with this filament on my Ender 3 using the stock plate. This filament is the second roll I've purchased since I started 3d printing. The first was another brand that I purchased going for low price. I figured any brand was the same as the other. Well, you get what you pay for. That filament almost put me off 3d printing with poor adhesion and terrible oozing problems.I tried this after the first roll ran out and the difference is night and day. Very little oozing and the adhesion is superb for me without having to use rafts or brims or anything applied to make it stick. Overall I'm completely happy with this product and I'm pretty close to buying another roll when the other runs out.

I'm generally a fan of Jayo but I ordered 2 rolls of the grey and both were very brittle. I kept getting breaks and had to continuously monitor the prints. I tried drying with no improvement. I also had a tangle on one of the spools and had I not been watching would've had a failure.All that being said, I was still happy with the printed quality.

I've had this PLA harden and snap from the spool to the extruder I believe 5 times now, causing several prints to fail and having to throw out a lot of the excess PLA that couldn't be salvaged.In terms of the prints that worked, they're completely fine, however the hardening and snapping make it so the amount of total prints you'll get less then you should.

Liked price..... you get what you pay for. I have had a really bad experience with this pla. It requires very high temperature, adhesion is poor, clogs nozzle and structural integrity seems lacking. It is like there are impurities in the pla. It acts more like petg. I dunno maybe I just got a bad spool.

This filament has the worst base layer adhesion of any I've used. It didn't matter temperature or what else I used to try to get it some help it almost always releases from the bed. Typically it's a corner that curls bad, but sometimes the entire work piece let's go about half way into a 4 hour piece. If you splice it in for a color change and have a good base it does ok.

Listen this fillament is garbage. It's extremely birttle and blobs up super easily. They got the near five star reveiw by switching what product this was originally to the fillament. Which was a decent machine to keep fillament dry. But that's why it's got such high reveiws. The fillament itself is actually quite garbage.