Affordura PWC Fender Bumper with Elastic Cords 2x 18.5 inch for Yamaha Jet Ski Dock Bumpers - 14 x 6 x 3.2 inch

Works great on my waverunner! I did buy a long bungee woth clips on both ends, that way I can have a bumper on both sides and it can go over the cover if needed

I don't have a good anchor point for a fender within range of the bungee cord near the front. My first attempt ended up with the fender and bungee cord falling into the water. Of course, the bungee cord separated and sank to the bottom. I found a better location that I could reach with a longer bungee cord. I discovered that I could tether the original bungee cord to the rear fender with a zip tie through the grommet and the loop in the bungee handle. The new bungee cord didn't have such a loop. So, I used a wire tie and wound it around the cord, just above the plastic hook. The zip tie and wire tie only act as tethers and do not support the fenders. The fender covers have withstood abrasion. So far, so good.

Bought a set for my SeaDoo GXT170. Big enough to protect well, without taking too much space when storing. Love the fact they “clip” under the bumper so they stay exactly where needed. Wish one end of bungle would clip to the bumper. Easy to drop in the water as you attach/unattach - and they don’t float.

These are great used them for a sho cruiser and jetblaster just buy a bungee with clips at the ends because first day I pulled it out on the water and the bungee fell in and sank immediately but product does the job I recommend

Great design and value

The product is durable and saves from scratch launching or tying the ski with the boat. Only problem is the bumpers keep on falling off the hooks or boat sides. Even little bit of waves will make it fall off. best is to ziptie the hooks with the bumpers to avoid if from falling off the hooks. i would rate this 3.5 for this.

As others have reviewed, they are a pain to set/configure if you have to reach into your bow to retrieve them, find the bungie cords and set them up all while floating next to a dock (especially if its wavy). But once these things are in place and secure, they are super effective and absolutely necessary when docking if you don't want to ding up your PWC when docking. I also have the Yamaha OEM bumpers, which I like, but they don't protect your PWC as well as these do. I use both together, especially if I'm docked in rougher waters. But I always prefer staying away from docks with a PWC. I'd way rather beach it or use SandSharks and tether it in the water away from docks that can destroy your PWC in a matter of minutes if not protected.

I do not recommend these. I place three bumpers in between my jet skis for protection and they DAMAGED my ski. The skis were tied together with the bumpers in-between. These bumpers have a metal support at the bottom inside the foam. Well this metal support pinched through the foam all the way out and was chipping away at my fiberglass. I came back to the ski with a lot of damage. Adding pictures for you to see. Stay away from these.