AUTOSAVER88 Soft Roll Up Truck Bed Tonneau Cover Compatible with Dodge Ram 1500 2019-2025 New Body Style 5.7ft w/o RamBox

All good Easy to install

ABSOLUTE JUNK!!!! DO NOT BUY!!! INSTRUCTIONS ARE TERRIBLE AND ONCE INSTALLED THE LOCKING HATCH END CAUSES THE OPPOSITE END TO POP UP WITH NO WAY OF LOCKING IT INTO PLACE AND IT DOES NOT FIT A 2020 DODGE RAM 1500. TOOLS OR ANY CARGO WILL GRT SOAKED AT EITHER END!!!!!

I've had a few of these on pickups over the years. For the price, it can't be beat. Used ones will cost you more. Here is my opiniion and observations. First the Good: - All in all the quality is great for the pricepoint. - Easy to install with no tools required. - Great instructions but prefer a booklet style versus a 3 foot long fold-out. - All metal hardware. I ordered this over the tri-fold style due this. - Easy to open and close compared to the tri-fold. My fear is the nylon levers on the tri-fold will eventually fail. - Material seems as good as others I've had in the past. - Nice and easy to latch system. - Great weatherstripping already installed on the rails. - Great double ir triple wiper style rear seal. Seals tight against the tailgate. Things that can be improved: - The velcro isn't an industrial use type. Other covers I've used has a very heavy duty type of velcro. I believe this is the weakest part of the system. - Should be wider. See next item. - I had an issue getting it to lay down properly in the rear right corner (see picture). It took me a minute to figure it out. It turns out the back rails were too wide so the door style latch wasn't catching properly on one side. To make it work, I had to move the cover rails so they over hanged inside the bed rails. Once I did this, it lached and laid down properly. Either the latch system needs improvement or it should at least be be documented in case others have this issue. - Even though I did make it fit, it seems too generic, like it fit several other trucks. Maybe not, my opinion... I believe I should be able to get several years of use from it, and it seems to seal very well, so I don't anticipate any leaks. I believe the strengths outweight the weaknesses once you work through them. Overall, I do recommend this bed cover.

It's not very strong. You literally have to loosen some screws and separate it a bit because it's not wide enough for the truck bed. There's just way better options available and for an equivalent price.... Amazon seems to be flooded with these cheap truck tops. Spend some time researching and don't buy this one.

I purchased this in hopes of keeping snow out of my bed. I didn't even think about keeping moisture out in general. That being said, it took less than 10 minutes to install, sealed to the box very well and can't be opened when the tailgate is locked, which is another peace of mind! I went through a car was with it and was amazed to find ZERO water in my bed. Super impressed!

Great value for the money while on sale for $130.00. Keeps bed 98% dry. Rolls up nicely allowing full use of bed when not closed. Makes a slight wobbling sound when driving 45+ mph with rear slider open just from the wind turbulence bouncing the cover up and down. Not a big issue, but worth mentioning. Would definitely buy again at $130.00

I installed this in 30 minutes without following any instructions. Very straightforward design. Fits like a glove. Tip: connect cover loosely to side bars and lock it in place before tightening, so you can confirm alignment and latch lock tension are correct.

It’s about 1 inch short on the sides and about the same for the length. I should have returned it because now when putting anything in the bed against any of the walls I have to take it all the way off. Ridiculous because it said it would fit.