1/4HP Furnace Blower Motor 1725RPM, 115V 5.2A Belt Drive Blower Motor Single Phase - 0.39" Shaft Diameter, 0.78" Shaft Length, CW/CCW Rotation

This motor works well, and can save a lot of money especially compared to a technician recommending a new furnace for $5000 or more. My original blower motor was installed incorrectly at the factory. Apparently, the mounting holes were not placed correctly so the factory installer removed a sleeve from one of the three isolation mounts to thread the screw into a misaligned hole. Also, the holes were not parallel to each other, making the new mounting brackets not fit. I bent the new mounting brackets and used two of them and one old one. The impeller is not centered in the housing, but rotates smoothly. There is no rumbling with operation, and the fan and motor are at least as quiet as the old one, but probably less noisy. The capacitor is round and would not fit where the old one was, so I mounted it on the sheet metal of the furnace instead of on the fan housing. Also, I had to use heat-shrink style crimped connectors for the wiring. The product is great, and I am pleased Amazon carries it. But if you expect a 30 minute installation, your experience may not match your expectations. The directions are poorly written English, probably simply machine translated from Chinese, and I think the coil resistance values are nonsense. I studied wiring diagrams before I started, twisted an allen wrench getting my old set screw loose, used a hammer and punch to remove the old motor shaft from the impeller, and drilled holes in my cabinet to mount the capacitor. The reward was perfect operation when I applied power to the furnace at job completion.

Excelent motor fix my home heating and save 500$

Simple swap out & works fine

Fixed my ac

Great replacement

Great universal blower motor. Used it to replace ADP motor 76700672 in an ADP BRCM3924S2N4 hydronic air handler. Easy replacement. The new motor comes wired with female space connectors, so I cut the plug off of the old motor and crimped male spade connectors onto the wires. The old motor was 3 speed, so I did not need the fourth speed of the new motor. working well at high speed after two days.

Matched up the specs from our trane xr80 furnace blower motor. So far works well. A little louder but thats ok. We had to drill new holes to mount it so install was a bit of a pain but works insantly. Would recommend!

I was looking for this purchase to review on it. I’ve had this motor for several months now AND… It is quieter, definitely more blow, more powerful, easy to install, well packaged and connectors are quality! Everything is there. If you struggle to pull off the old basket, spray with penetration oil and use a gear puller so you don’t dent the blower bearing housing. If your an armature, take detailed pictures of the connection points on the circuit board.