Taiss 2pcs Black Aluminum Rotary Electronic Control Potentiometer, Volume & Switch Knob, 20mm Dia. x 17mm Height for 6mm Shaft

Good knobs, easy to install.

Had to modify to get it to fit properly, hole is too small, so expect to drill slightly

Bought them to replace a missing knob on a controller I have. Works and fit just fine.

Perfectly machined and dimensions match what's listed exactly. They look great and I'd gladly buy again to use on other instruments.

One out of two miss-machined. The set screw on one was tapped at an angle. Hopefully it will hold tight to the pot shaft. - edited - contacted Sea Gull and they made it right, sending replacement knob!

These knobs fit on my squier paranormal just fine and appear to be functional. They look okay but have a dull matte finish compared to the squire factory knobs and to their own picture on Amazon. I'm happy enough.

Mine came with black set screws contrary to what's pictured which is a plus. Nicely machined from one piece of aluminum, no wobble. Shaft hole rather deep.

I like these knobs a lot and have bought silver and black versions. The black versions have silver set screws and really ruin the look for me. Details matter. Otherwise, why are you replacing your old knobs? Also, the set screws strip easily. Use caution when tightening. Old knobs have hard steel set screws and never strip. Old versions also have much smaller set screw diameters. I miss that quality that you really can't find anymore. These ARE attractive knobs. I just don't like the silver set screw.One last problem for ME ONLY: They don't come in 1/4" shaft mountings so I need to drill them out. It's not hard as the aluminum is soft . I used vice grips and a rag to hold and protect the knobs during drilling. No drill press required. The black finish is delicate. I did ruin a few because the rag was too thin and the knob slipped while drilling. Use caution if you'll be enlarging the mounting hole.