LGDehome TCRT5000 Infrared Signal Reflective Track Sensor (3.3V-5V),IR Photoelectric Switch Barrier Line Indicator Module for Robot Arm Smart Car Robotic Kit (Pack of 10)
Description
- Wide Application:For obstacle detection,Watt meter pulse data sampling,Detecting black and white line ,Detecting Fax machine and shredder paper,for limits of movement on robotic arm Parameter: Working voltage:3.3V-5V, Detecting reflection distance:fit for 1mm-25mm, Dimemsion:1.5〃x0.55〃x0.7〃(L*W*H)/3.8cmx1.4cmx1.8cm(L*W*H) How to Wiring:VCC: Connect the positive pole of the power supply (3-5V);GND: Connect the negative pole of the power supply;DO: TTL switch signal output;AO: analog signal output Easily Installation:Design with bolt holes for easy installation.Use wide voltage LM393 comparator,With potentiometer to adjust sensitivity Output form: digital switching output (0 and 1),Comparator output, clean signal, good waveform, strong drive capability, over 15mA
Introduction: When the Indicator diode is lighted: That mean the target is beyonded the range of the detection.and the The infrared light can be reflected back ,the intensity is power enough, the infrared receiving tube is saturated, and the output of the module is Low level. However the Indicator diode is off: Which mean the infrared light can not be reflected back ,the intensity isn't power enough.The infrared receiving tube is in the off , at the same time, the output of the module is high level.Specification: 2.Working voltage 3.3V-5V 3.Detection of reflection distance: 1mm ~ 25mm 4.The comparator output, the signal is clean, the waveform is good, the driving ability is strong, more than 15mA 5.Output form: digital switch output (0 and 1) 6.Using a wide voltage LM393 comparator 7.With fixed bolt holes for easy installation 8.With potentiometer adjustment sensitivity 9.Using TCRT5000 infrared reflection sensorPackage Included: 10pcs TCRT5000 Infrared Reflective IR Sensor Module
Reviews
O**E
Worked great in my candy dispenser.
I made a touchless candy dispenser for the pandemic. I used 3 of these sensors. One would start the machine when a hand was waved under it and two were used to sense if the candy dropped out. All three worked perfectly. It is important to note that the range of these sensors isn't very far, but for me that was fine. The sensitivity adjustment potentiometer worked fine as well.I know some people have had issues with not all of them working, but I don't see any reason to lower the stars since everything worked as expected for me. If I have a problem with any of the remaining 7 sensors, I'll update this review.These sensors were used with an Arduino Nano.
A**D
They work, for the most part
Out of the 10, 2 of them were defective since none of the LEDs would glow and no data was being outputted to the digital or analog outputs. They should be tested before being implemented into a project. Despite this, the sensors worked well in my project, and having both an analog and digital output is a huge plus. The digital output can be easily adjusted with the potentiometer on the board.
M**9
Works as intended
Great price for a bunch of sensors. So far all the ones I've used worked
S**N
Adequate for prototyping.
Functioned adequately, though due to quality assurance shortcomings some of leds needed to be resoldered or bent into a usable position. Nevertheless, all components functioned properly.
E**E
Good sensor
The sensors were great and it came on time as well. I was able to finish my project.
Common Questions
Trustpilot
5 days ago
1 month ago
