OXO Good Grips Microfiber Extendable Duster 52 inches

We own a few similar microfiber dusting devices on long poles so I was a bit skeptical when this was recommended on a TikTok video by a professional cleaner, but I’m a believer now. This thing is great! I don’t know what makes it grab so much better but it really grabs and locks the dust. I was able to dust my walls, ledges and high areas/artwork, after some house remodeling and it worked amazingly well. My only suggestion would be to offer two sizes. It would have been good to have one with a head that is twice this size to cover more surface area with one pass. I also wish there was one with a telescopic handle that was longer so I could reach my high ceilings easier. But even without these options, I would buy this again in a heartbeat. It’s that good.

The product is fine, as advertised. However, it arrived dirty, with sticks and discoloration on it. It will have to be cleaned before use. Not wrapped, just a label slapped on the plastic that covered the duster piece. I don't know if it was in the bottom of someone's car or in a dirty warehouse, but not acceptable.

This extendable duster has a number of good points, and one relatively minor limitation. On the plus side, it complements the OXO hand duster quite well, accepting the same quality dusting sleeves as its little brother (you can read my review on the OXO hand duster here on Amazon) while at the same time allowing access to many (but not all .... see below) otherwise unreachable surfaces. The extending rod mechanism works well, and the angle between the rigid dusting sleeve at the end of the unit and the extended handle is essentially infinitely adjustable for maximum efficiency. I suppose it might be sufficient to just buy this extending rod version of the duster, with the idea that with the handle at its shortest one could use it in the same way as the standard OXO duster. I didn't try this, but I believe the standard duster, also available from Amazon, might be more comfortable to use against easily reachable dust. One thing that annoyed me about this duster is that, in order to generate the rich variation of dusting angle mentioned above, the unit is designed with a kind of knob at the business end of the pole, and protruding out at right angles from the plane of the dusting tongue. I found that this knob is big enough that it gets in the way of trying to slide the unit - with the dusting sleeve fully extended at 180 degrees - between a bit piece of unmovable furniture and the wall, limiting my reach of long settled dust. I think I noticed on Amazon other versions of a kind of dusting pole arrangement that were simpler than the OXO, with perhaps no flexibility on dusting angle but also with no obstructing knobs. I may, in the end, try one of these alternative products to reach difficult spots in the house. In my review of the OXO hand duster, I included some details of my experiences and thoughts on washing and drying the dusting sleeves that are common the both OXO dusters. I've appended this discussion here, along with a picture of a custom, easy to make drying apparatus: To get more use out of the duster before it became saturated with dust, I used a rechargeable hand vacuum a couple times to get most of the dust off the duster. When that move seemed to have reached its limit, I swapped out the microfiber sleeve for a new one, which I had the foresight to buy in the same order as the duster. The simple snap that anchors the sleeve onto the handle is easy to work with and swapping is, indeed, a snap. This whole strategy went well and it is an approach I plan to continue to use. (Although purists might argue that unless the hand vacuum has a HEPA filter, vacuuming the dust from the sleeve while in the house might just end up redistributing some small dust particles. Just throwing that out there - I plan to continue to do the vacuuming, especially if the alternative is to stand on the porch and wack the dusty sleeve - it seems to me that is a recipe for redistributing dust, directly into your lungs!) I was surprised, when the duster arrived, that it is not cylindrical, but rather is a kind of dusting tongue. This actually is an advantage, since it means the tongue will reach into awkward places, like behind unmovable furniture, a little more easily (but note the concern above about the knob on the extender version of this duster). While the product literature stresses to only use hand washing and hand drying, I experimented a bit, with (so far) good results. I have a recently purchased LG top loading machine that does not have an agitator, and I guessed that this might be gentle enough, with cold water and a "delicate", low spin speed setting, to not injure the fabric. This seems to have worked well. It got the sleeves free of dust, without causing any noticeable shedding of the bright orange microfiber. I actually wonder whether hand washing might even be less gentle, while at the same time clearing out less wash water than the low spin in the machine wash. One caution - if you do use the machine wash, the dust has to go somewhere, and that somewhere is your drain; I noticed that the replaceable lint filter I have on the drain tube was dirtier than it had been after I did a wash of four dust-rich dusting sleeves - but on the bright side it also contained no noticeable orange microfiber! Overall, I will continue to use the machine wash and live with more frequent changes in the drain filter, if it comes to that. For the drying, I had an inspiration that turned out to be quite productive. Thinking about how I was going to airdry the duster sleeves, I realized I could easily bend a standard, cheap wire shirt hanger to create drying frames that approximate the plastic loop of the duster unit that the fabric sleeve slides over. This was easily done with a couple of pliers to generate the Duster Sleeve Drying Frame (patent pending) shown in the photograph attached. There are two drying units shown: the one in the back is outfitted with two orange microfiber sleeves just out of the washing machine; the unit in the foreground is empty, so you can see how it was bent to accommodate two sleeves. In this design the hanger hook is left intact so it can be used on a pole like a standard hanger. The side prongs for attaching the sleeves are angled upward as much as possible to limit the possibility that the sleeve might slide off - although this did not seem to be a problem, presumably because I left the wire loop wide enough that the fit was snug. (I note that this idea will work well if two washed sleeves are attached; with only one attached it will dip down and the sleeve is perhaps more likely to drop off.) After hanging like this overnight in the laundry area of the basement, the sleeves were dry, very fluffy, and ready to go at it once more. And again, no noticeable shedding of the microfiber.

This was delivered today with the other dusters. I love them - super soft, pretty, and excellent at picking up dust. Now I can dust my ceiling fan with the extender duster (and it really needed it). Both the hand and extender and refill are excellent and I am so very happy I ordered them!!!’

Great duster, sturdy

July 2013: The microfiber head really picks up dust well. I'm especially happy with how clean it leaves the plastic casing on my plasma TV and computer monitors. I used to waste so much time trying to dust because Whiffers, paper towels and rags all leave as much dust as they pick up. Dusting is now faster and cleaner. The dust stays on the head until shaken clean (I rap it against the metal bars on my porch and I can actually see bursts of dust shake out). The major downside is that the joint that allows the head to bend at an angle is way too bulky. The hard plastic joint area is totally exposed, even when not bent. There is nothing to protect surfaces from getting scratched or damaged (I must be ultra-careful cleaning my TV screen, for example). I took two stars away for this extra-poor design. If you look at the pictures of this OXO duster carefully, you can clearly see what I mean. November 5, 2014: After inadvertently breaking the handle, I purchased another OXO Good-Grips microfiber duster a couple of weeks ago. What a disappointment. The duster is now thinner and narrower than the one I had purchased in July 2013. It also does not pick up dust well. This new version puts most of the dust back onto the furniture. It sheds a lot more than the one I purchased last year, leaving a trail of orange fiber wherever I walk. Fortunately, I still have my earlier duster, so I was able to salvage this purchase by replacing the useless duster with my old one, which after 15 months of continuous use still picks up dust like a champ. I do not recommend this new version of the OXO Good-Grips Microfiber Extendable Duster. Perhaps some other reviewer can recommend a better product. Better still, perhaps the manufacturer will salvage its brand by offering a better quality product.

I bought this product because I saw it in my local hardware store and figured it would save my back from spasms when I try to dust high or low places. Well, I was right. It works beautifully and Amazon price was cheaper. Some reviews say extender doesn’t hold. You have to turn the orange piece to lock it in place after you extend it. Also, don’t force bend it. Push the black lever near the head to change degree angle. Sturdy item. Easy to hand wash microfiber head in cold water and air dry. Very pleased. Shoulda bought this years ago.

Great for dusting in high up places! It is very light and sturdy. Love that I can throw the mop head in the washer. It is a great size!

Assolutamente di una comodità estrema per spolverare dappertutto, anche sopra ai mobili perché ha il manico allungabile e il piumino si può angolare in base alle proprie esigenze. Piumino morbido, non graffia e cattura bene la polvere senza spostarla. Acquisto consigliato. Spedizione e consegna perfetta.

Used for the top edges of kitchen counters under low beds and hard to reach places. This has a brilliant extendable handle and the microfibre head is easy to hoover off or wash. The head can also turn in different directions backwards and forwards for those tricky angles. The duster is also soft and picks up and retains the dust, which is very important as we have someone with a dust mite allergy in the house. Have been using it for about 4 months now and so far so good. I would definitely buy another when needed, so don't hesitate if you need a long handled flat duster. It would be great if it came with a spare duster head so one could be washed whilst other is in use. But that's just a nice extra to have.

Better than another duster I bought on here that broke in no time. This one is durable, useful, and you can wash the head. As a house cleaner I find it very useful

I love it! It reaches all the hard places with ease. Dusting the ceiling fan and the tops of cupboards is now a breeze. It grips the dust so you don't get dust flying everywhere. I've watched it twice now and it comes up well. There is a bit of tangle with cobwebs but nothing that affects its performance. Its made all the hard out of reach jobs very easy now.

For the quality the item is too high on the price