Vinyl Works Deluxe Adjustable 24 Inch Wide in Pool Step Ladder Entry System for Above Ground Swimming Pools with Non Slip Steps, Taupe

Bought this to replace an older version of the same ladder it was easy to assemble and went right into place after holding under water for a few seconds.

We bought this to replace the A frame ladder that came with our pool after we built a wrap around deck and could no longer use the ladder that goes inside and outside the pool. As with all of my pool purchases I read a lot of reviews before I buy anything because it is sooo expensive for pool stuff and sometimes it's still junk. I would agree with other reviewers that it was a bit of work to put it together, but certainly less difficult that the ladder that came with the pool. Anybody could probably do it. My husband put it together inside - don't do this it left little plastic shavings everywhere. We had to trim the arms to get them to fit but the instructions tell you to do this so you will need a saw. I was hesitant to drill holes in my resin top ledge, but there is no way it would be sturdy without doing this. Holes were easy to make and doesn't seem to bother the pool much. My husband is 6'3" and almost 300 lbs - didn't budge when he gets in or out. He did drill a couple holes in the inside where nobody could see them to fill it with water. Like another reviewer said, it still wants to float but just barely. This actually takes up less space than the A ladder we had been using that came with the pool. And it was scary getting in and out because it would wobble side to side. If I had to dig deep and find anything I don't like so far - I don't really care for the hole in the middle where the light can go. I wish there was a piece there you had to pop out if you were going to use the light. We went with a return fitting light (you can read my review on that too - LOVE IT!). But honestly it's not that noticeable. One thing worth noting, there's a circle notch on the outside of each of the arms outside of the pool. I have no idea what these are for. Maybe to hang a sign that says "pool closed?" or something across the ladder arms? Not sure but the instructions don't say anywhere what these are for. Overall very pleased, would buy again.

These steps work well for our pool. I had to make some mounting modifications only because of my deck design. They were easy to assemble and install. I did not use gravel for additional weight and had to have help keeping them down in the water for installation but had fun doing it. The only thing I don't like are the handrails, they are a little wobbly, I have to make sure the kids don't hang on them just in case... but I would buy these again.

Unit was very easy to install. Directions were decent. There were a lot of photos to clarify steps. I drilled the 1/4 inch holes the instructions suggested and the treads and risers filled with water very fast. The instructions said to add 10 to 15 pounds of clean gravel to each stringer. I added 30 pounds of sand in each and there was plenty of room for more. With the 60 pounds the ladder does not move at all. Adding sand was tedious the holes are small. I used a funnel and a gallon bucket to add sand it took a while but worth the effort. The only issue I had was the rear deck flanges. The directions say to drill a 5/16 hole and use a 3/4 bolt nut and washer to secure the upper rail to the flange. The washers are too big to fit into the area where the bolt goes. I installed without the washers and next time I am at the hardware store I will see if I can find some with a smaller outside diameter. The upper rails flex a bit but not nearly as bad as the A frame ladder I had prior. I think metal rails for the top would be better.

I am quite satisfied with the quality of the pool ladder; I would describe it as a fantastic set of ladders.

They are exactly as pictured, however,I never thought I would have to bend the steps. They require serious strength and " sitting in sun" to make them pliable enough for bending. Thankfully my son was able to do it.

I hope you have 2-4 hours to dedicate to putting this together! The instructions are a joke. Two people trying to read and follow the instructions provided and it took close to 4 hours to get it all together and in the pool. Finally found a video on youtube which helped 100%. Once together, the top rail is VERY flimsy. There are not enough holes to allow water into the ladder to keep it down in the water. It was suggested to put rocks into the ladder. SO go spend more money for that. We chose to drill more holes to allow more water into the ladder which did the trick. This design, the top rail is very wide, meaning the top rail design comes over and forward so wide it takes up a lot of deck. Overall I would not recommend this ladder to ANYONE!

I bought upgraded steps when we bought the pool and it was hard to put together and it always came a part. We spent about $300.00. This ladder is more a ladder then steps because it stays closer to the pool wall but they are very solid and were easy to adjust since our deck is a little lower then the pool. The only issue I had was how the steps themselves fit in to each of the side pieces BUT once I figured that out they went together quite easily and they stayed together all the way from inside the house ( it was a hot day) to the pool at the side of the back yard.