108 PCS 15/30/45 Amp Power Connectors Assortment Kit, Quick Disconnect Battery Connector Modular Terminals Connectors, AWG10-20

I ran out of Anderson Powerpole connectors and needed to replenish my stock. I decided to give these a shot. The terminals fit perfectly into my crimping tool and crimped onto the wires nicely. The plastic connectors fit over the terminals correctly and snap in place with mating connectors just like you'd expect. Overall, I'm satisfied with these BULVACK connectors.

good quality as advertised, i bought to repair an electric scooter, because the battery cables from the manufacture were $110 dollars each .

Perfect mini anderson connectors. My only "complaint" because they're so small they bend slightly when crimping and require some realignment when being installed in the plastic housing to ensure they fully seat and stay in place. Definitely recommend for lower amperage applications.

This is a good assortment of terminals and shells. They seem to fit together ok, not sure if they will fit with original Anderson PP, but don't imagine they wouldn't. The shells fit together ok--just a little tight for alignment and disassembly. Nice hard plastic. I have a pickup power-outlet project going on and these should be a few more than enough for now. The box could be a little more rugged (hinge was popped open and contents were mixed up) maybe that's why it's in a bag too. It would be nice if I could find some little seal-plugs to go over the wires and into the sockets to make them a little more weather-proof, but that's probably not an original design expectation for these. I "knew" how small these would be but was still a little surprised. No idea about technical performance (contact heating under load, contact wear, housing ruggedness outdoors, etc). They look like they should crimp on as well as any, expecting same. It they turn out differently I will revisit this review.

These have worked well for me, so far. They seem to be a clone of Andersen powerpoles. No little “A” like on the originals, if I am remembering correctly. The 15 and 30 amp contacts have crimped well using the proper powerpole crimper tool. I always start off the 45 amp contacts first by crimping the upper edge of the “sleeve” area together a little bit with pliers before inserting into the powerpole crimper tool. If I don’t get it started, sometimes the 45 amp contact crimp folds only on one side and has to be replaced. This is no different than I do on original branded 45 amp contacts. I’m satisfied with how these have worked for me. Will see how these hold up over time.

This is a great kit for making multiple Anderson Power Pole connections. I also purchased a 1-in 8-out fused power block, and these match up perfectly.

These do not fit Anderson Power poles! They are a different size and do not match up. I was very disappointed.

These connectors are so simple to make, and they lock negative and positive end together! I am sold and will be using these from now on, as a matter of fact, I am going to re-do my entire ham shack with them! Word of warning however, you will need also to order the IWISS Wire Crimping Tool sold elsewhere on Amazon in order to make the proper connections that slide into the plastic housing. Well worth the money in my opinion!

Pour connecter radioamateur

I bought one a month ago and it was $5 cheaper plus free shipping. Now the shipping is $6. The connectors look the same as far as I can tell so far, so that's good. The case is slightly different, no label anymore. Left is the new one. Right is the older one.

Not enough electrical connections vs plastic covers. Could not finish my project.

I didn’t use them away to small not what I expected.

Not of usable quality