5-160X U-Joint Kit 1410 Series (OSR)

Spicer is the best U-joints in my opinion. Shipping was fast, and they fit perfect!

Works as it should!

fit perfect on a 09 nissan titan 2wd in all 3 spots on the drive shaft, high quality made in the usa :)

Fit great

Well these are great u joints except they weren’t the right placement for me. Supposed to fit rear driveshaft to rear in my 09 ram2500 but they were just a little to wide to fit in between the yokes. So I had to buy a different set. Either way the product alone is great.

I installed 3 of these u-joints and the carrier bearing (also Spicer). Until I did this I was not positive I actually needed them. But two things were immediately apparent. When I push in the clutch to start my engine, the truck starts to roll on the driveway. Before this the carrier bearing was so dry and sticky that it could act as a hill holder. It's only a very slight grade but wow! Second, the drive-line slap (play) is completely gone and when I let off the gas/throttle there is a smooth deceleration without any bumping, hunting, or popping. The dealer wanted over 800 to do this job, and their parts totaled more than 400. I did this job with a friend, in my driveway, in about 4 hours. We reused the rubber boot and the straps on the boot. No seals were needed at the differential or transmission because those were previously serviced. The U-joints come with Zirc fittings (8mm not 5/16"). No special tools were used -- a large vise, mallet, ball peen, chisel, needle nose pliers, large c-clamp, large sockets, penetrating oil, blue thread locker.

This fit my truck perfectly at the rear u-joint.

I was hoping to find a QUALITY replacement U-Joint. I chose Spicer, as it has always been considered a top brand. Very disappointed to find they are now manufactured in CHINA. I've had poor luck with Chinese bearings. We'll see how well these hold up. Not expecting much life out of these.

Great quality. 1410 series

Worth every penny. Buy the best and forget about it ever being a problem.

Seems like a good product, when you pull it apart to put the caps back on, make sure all the rollers are in their proper spots.