Waste Trap

Great quality material at great price. Clear instructions provided. Looks great. Definitely recommend.

Overall this bottle trap appear to be pretty good quality wise, with a good heavy weight to it.The only downside for me is that it appears to drain very slowly, which I suspect may have something to do with the plastic inner sleeve inside the bottle.I think this may require further investigation.Apart from this, it's ok.

Fitted easily and works with no leaks.One of the main reasons I bought this item was that the information provided on the Amazon website included a full breakdown drawing with dimensions of what was included. I needed to replace an existing bottle trap, so already had the horizontal pipe from the trap to the wall fitting. I needed to know the diameter of the supplied pipe to ensure it was the same as my one, and how it fitted to the trap (using either a flat flange or pushfit into the trap. All was good so I ordered it.My old bottle trap leaked after I installed a new waste. The seals were no longer flexible. I replaced one seal but it wasn't right, and despite copious dollops of joint sealant, I couldn't stop the drip, so I cut my losses and bought this new one (a bit trendier than my old one). It looks good, has good seals, is solid and is a good price. I was a bit worried about the lack of knurling on the nuts but I needn't have worried - the nuts only needs to be hand-tight

Excellent quality and finish. Exceeded my expectations. Very reasonably priced for this high quality.

Looks great and smaller than the previous trap on my bathroom sink. However this has a major design flaw with the bottom screw cap, the one which you use to remove/recover rings etc which may fall down the plug hole. The rubber gasket is far too small and when you tighten it doesnt seal. After spending over £10 in a new seal for the top (where the trap meets the sink and the usual source of leakage) I then purchased some PTFE (thankfully very inexpensive at 37p from Amazon) and wrapped a few dozen times around the bottom cap. three days after initially fitting the trap there are now no leaks. Wife happy, so happy life.

Purchased this to replace another chrome bottle trap that we had on the sink for a while, which had a broken washer, so was cheaper/easier to replace the whole thing these days than try and spend ages looking for the correct size washer.It's a simple fit, no leaks, and to some of the reviews that mention slow-draining, you need to remove the little black plastic 'bucket' that sits inside the bottle area (unscrew the bottom and take it out) not sure what it's there for, but the sink nearly overflowed when leaving it in! And has worked fine without it, so assume it's not needed!Overall, very happy with it.

Used under a square bathroom sink mounted on the wall. So far so good.

Replacement for previous trap which rusted and fell apart. Was relatively straightforward to install, the box contained a few washers and one of them fitted into the hole in the wall. Make sure you have a hacksaw with a sharp blade to cut the metal pipe that goes into the wall. I nearly ruined it. Excellent value and looks great.