iCreating 8mm 2 Pin LED Strip Connector with Pigtail (10pcs) 3528 Flexible LED Connector Solderless Clamp On Pigtail Adapter for 8mm Wide SMD 3528 2835 Single Color Flexible LED Tape

Used then to install led lights in my rv excellent result would use them again defently

Brilliant and easy to fit, works a treat

A little bit fiddly when using the clip, but did the job well

They work. Haven't failed yet

Good!

Wires are too short on non clip side to do anything with, and wires are too brittle inside to use wire strippers. I found them useless

I like these connectors & how they work. they are solder-less. the connect easily to the strips & have very good connectivity. although I did solder the wires together at the end opposite end (the end not connecting to the strip) i suppose u could use a butt connector. t liked em so much I bought more!!

This is my first experience trying to repair a defective LED strip light section. The origional connector did not line up precicely and did not lock tightly enough which resulted in the lights flickering. These connectors worked great. They are easy to line up and they lock tight. Thanks for a quality product!

Great product. They do overlap the first LED chip on dense strips. We had to notch the plastic to be able to use them on some 3528 strips. Perhaps a little more engineering will solve that issue. Overall, good product in situations where soldering leads is not a good alternative.

I bought some LED strip lights for under cabinet lighting in the kitchen. I did a test install first before drilling holes and securing everything permanently. I didn’t believe the reviews about soldering to the strips being a pain. Should have listened. Yes, soldering definitely works if you have a decent station,some experience and a lot of patience. Not fun though. After my test run I immediately ordered these clips. They work great and are absolutely worth the few extra dollars.

These connectors worked great! They snap shut and lock - did not have any issues with getting a good connection with the strips. Note: If you purchase the 8mm waterproof strips, you will need to cut and peel off the silicone coating above the connector pads. This proved to be pretty simple... I used a single edged razor blade...take your time and be careful not to cut down thru the strip.