Stick On Gasket for 3D Resin Printers - Universal Protection from Resin Spill, Internal, LCD, FEP Film - Resin Resistant - Portable Protection - 4.7" W x 7" L [ 3-Pack ] (6 Inch Screen)

I bought this and the screen protectors for my Voxelab Proxima 6.0 both from the same company. These fit perfectly the screen protectors were a tiny bit big, but both work and look great. I had a bit of a resin issue when my FEP got a tiny hole in it. I wish i had this before that but i have them now and everyone with a resin printer should be using them.

These gaskets certainly do what they are designed to do, keeping resin from getting around or behind the screen in the case of a spill. HOWEVER, the most amazing, and unexpected, positive side effect of these gaskets are when leveling the build plate never having to fiddle with a scrap of paper that is nearly held tight, and nearly moving freely, and never knowing if it was correct. Home the build plate, tighten the set screws, rise the plate 3 times at the smallest increment, and set home. No more artistic tugging of part of a sheet of paper. Also however, everyone complaining about how fiddley it was to apply are 100% correct. Worth having, but it takes longer to get it applied than anyone would like, but it is important to get right.

This gasket works well with the mono price SE. Its a bit difficult to get it onto the plate correctly, but its quality and worth the price. You also get an extra

Not a truly inspired design but it still has it's merits and it can contribute to saving yourself some headache too. I feel like this is a novelty type of item for anyone that is really diligent about their printers and their setup but as someone who can be forgetful, less than thorough and even lazy at times this thing has probably saved me some headache here and there so I have to give it credit. I would likely be in the market for more of them if they were priced a little lower but it is what it is and I don't hate it.

Used in my Photon. After a few tries managed to get it on without covering any of the led. Very difficult on photon due to the little stands the vat attaches to, but now that it's on I can tell it will save me some grief since the space ensures it doesn't vacuum to the LCD after every use. Also makes leveling less of a chore. Just bring it down slowly till it's flush and move it back .02mm (the manual says .03mm but .02mm worked better for me.) The paper method makes it difficult to Align and without the paper as a factor I can just eyeball the small adjustments A photon guide would be handy, perhaps having the tape be in several pre-measured bits with a picture to help with alignment. Other than that, no complaints.

This product is advertised for the Photon Mono but unfortunately it just does not overlap with the screen correctly. No matter how I orient it, there is a gap on the left or right hand side. The product itself seems wonderful and I’m giving it at least 3 stars because of that. I didn’t have any problems trying to install it though I can understand why some do. My only issue is just that it is slightly too big for the photon mono.

I made a small mistake of putting this on before protective screen but it was easy to remove and readjust

I can wipe up spilled resin if it happens again and hopefully dont have to buy anymore screens. A bit of a pain to get just right but you get more than one if you mess up. Lol