1-4Pin Wire Connector

Works great! Water resistant! Used it to rewire my motorcycle, works great so far

Used to wire up some fog lights. Nice to be able to get a cleaner install. Working with thicker gauge wire isn't the easiest but that's my problem. There is a world of difference compared to some of the connectors on cheap harnesses I have received with things in the past

I find this a very cost effective way to establish non critical connections. I cannot attest to its water proof nature or if it really can handle ten amps of current across those small contacts. However I believe it to be a cost effective solution for many applications. There are no directions that come with this kit. It is pretty intuitive with the possible exception of the little red inserts. I questioned the vendor and he sent me some guidance that was pretty good. Once I realized that the red insert went into the connector half that did not already have one, it was pretty strait forward from there. It struggles to accommodate large diameter wires (18 Ga with what I would consider standard insulation) as it becomes difficult to get the water seal properly retained and crimped. Proper orientation of the locking tangs was another question. However you can look down the barrel of the connector and see the retaining lock so that is not an issue. Just line the retaining tangs up with the retaining locks and you are all set.All of these things are relatively minor however the fact that you cannot remove the pin once it is locked in may be an issue for some.I was all set to use my razzle dazzle ratchet crimpers on these connections when I discovered that even though they had a "B" crimp die set, the jaws were too wide. A standard "B" crimp tool works great but you may need to crimp it twice to get it tight.One added plus - I grabbed a sensor cable from a 2006 Chevrolet because it looked like a direct fit. After mating it to one of these connectors I was able to measure continuity through the pair.

Works great clips are solid once crimped.Make sure you get a proper crimping tool.

Using these for tail lights on a motorcycle. The OEM was hard wired. Didn’t want to do that again, so trying these connectors. They can be tricky to use. Practice on one first. The hard thing is where to crimp the exposed wires and not the little wings that lock it in place.And I cannot figure out how to get one out when you want to do it.

Más o menos cumple pero la calidad de los materiales no me convence mucho ..

Simple to use and worked great for my tail light connections.

They look decent but I had ordered the wrong style so I have not needed a use for these. My bad , it’s on me.