Frameless Shower Door Bottom Seal with Drip Rail 3/8" Thick Glass 27.5" Long Sweep - Glass Door Seal Strip Stop Shower Leaks

I liked the very long splash stopper and it was easy to trim to the required height.

La pestaña que cubre el hueco entre el Cristal y el suelo tiene la dimensión apropiada para evitar el escurrimiento

Bottom seal arrived on time in a long box, so the seal was not folded or kinked. Before installation, I measured and trimmed it to length using a band saw, which made a clean cut. Out of curiosity, I tried to cut pieces off the scrap piece using scissors, a heavier duty shear, and a wood chisel and hammer. All left a jagged edge. I then used a small hand saw with fine teeth, similar to a hacksaw, and it cut easily leaving a clean edge. Installation was simple. The fit in both length and height was perfect. Very pleased with how tightly the seal gripped the 1/4" thick glass door without using any adhesive or caulk. No water leaked below the skirt of the seal during an extended test shower, nor did any water drip on the bathroom floor after the shower when the door was opened outward over the floor. Very impressive. I highly recommend the product and am glad I bought it.

The factory sweep on our Kohler Revel shower door eventually became very discolored and finally cracked. The official replacement part is 1318765-01 (for 1/4" glass) or 1318766-01 (for 5/8" glass) and lists for at least $150, if you can find it at all. That's ridiculous! It didn't even fit very well to begin with. However, it is a tricky replacement to find because the gap between the bottom of the glass and the threshold is about 1", but there is a dam almost 1/2" high on the outside of the threshold. The sweep must be wide enough to fill the 1" gap but flexible enough to go over the dam. Of all the options I looked at, this is the only one with the right dimensions and design, and it worked perfectly! It was easy to install, and I haven't seen a drop of water find its way out since. It was also packed in a nice long box so it wasn't kinked or bent at all. Installation is simple, but here's a tip: to cut it to size, fit it on the bottom of the door, facing BACKWARDS, with the angled flap outside the shower and the excess length to the outside, farthest from the door hinge. A loose fit will do; don't push it fully onto the glass. Mark and cut to length. Then, pull it off and install it in the correct orientation. Now your cut will be hidden against the hinge and the visible end at the bottom outside corner of the door will be the perfect factory end.

Esta un poco corta y no proteje la salida de agua de la regadera, yo tenia otra un poco mas larga y no salia nada de la regadera, pero en general bien