Touch Lamp Switch 2 Pack, Touch Lamp Control Module for Dimmable LED, Incandescent, Halogen Bulbs, Lamp Switch Replacement Kit, Touch Dimmer Sensor with 3 Levels Brightness and Wiring Caps

Worked like a charm on my 2 vintage atomic lamps. Easy wiring diagrams, minimal tools needed. Been using for about 3-4 months, no flickering, no overheating, works reliably.

Needed to replace the 3-way switch in one of my touch lamps. This switch is very small, which is what I needed. Easy to install, fit perfectly, worked on the first try, and now I don't have to replace my lamps. Two thumbs up!

Works well. It turns a lamp on or off, but also gives the light 3 levels of dim. Nice touch. I liked it so much that I ordered 6 more.

Will not work with a grounded light fixture or lamp that uses a ground. I purchased these dimmers to use with hard wired sconce light fixtures. When attaching the sensor wire to the body of the wall sconce I naturally attached the ground wire in the metal junction box (electrical code) it rendered the switch inoperable. I had to insulate the ground wire that feeds the junction box from the box and fixture then the switch worked as designed.

I'm only speaking from personal experience, this is not written anywhere on the installation guide. If you use this control module with incandescent lights (bulbs) it will likely not last very long. I can only assume that the higher amps drawn from incandescent bulbs are too much and it causes the module to overheat and stop working. The device itself works great, however, IMO if you are going to use this with lamps that stay on for more than an hour or so I would HIGHLY recommend using only LED bulbs. I went through four [4] control modules on two [2] lamps to figure that out. I hope that helps someone.

Replacement switch worked great!

Worked perfectly. I have two touch lamps (3 levels of brightness) that stopped working. Bought these in hopes it was the issue. Simple to install.

I had a great touch lamp from a thrift store. It's fairly old. In a lightning storm that took out quite a few electronics around the home, said lamp was a casualty. I know the lamp is fairly old, only by the circuitry of it's original touch switch. Big fat old school through hole soldering, solid and effective. This swap was easy enough. I've had to dock some stars here though, because this switch is substantially less responsive. I almost always have to repeatedly touch and or rub this lamp to turn it on. Interestingly, this is only after a period of being off. Once it's going, it's perfectly responsive. But that's not really helpful. The original switch of visibly older circuitry, (really looks like a board from the 80's, maybe even late 70's) didn't do this. One touch, on. So, this does technically function, but not as well as a 40 year old touch lamp should.

Didn't work

es adecuado para lámparas donde el interruptor es tipo táctil, son 2 interruptores independientes y cada uno tiene lo necesario para su alambrado

Fue un simple reemplazo de partes que no requirió mucho tiempo. Funciona como se espera y vale la pena tener uno de repuesto en caso de tener este tipo de lámparas.

Funcionan muy bien y fueron entregados antes del tiempo programado. Excelente servicio

Excelente