Wostore Eccentric Flaring Kit, 7 Dies 3/16-3/4" 45° Heavy Duty HVAC

When I first looked at this, I thought it was defective. It is a eccentric flairing tool and it works super well. All my HVAC fairs were perfect. Super easy to use and a great tool. A little different from other flair tools but works well and makes perfect flairs...easily!

I purchased this kit to shorten the copper tubing to the minimum required length on my mini-split air conditioner. I did not want a large coil of tubing behind the unit. The tubing cutter and flairing tools worked perfectly providing an excellent result.

Used this kit for HVAC line prep and brake tubing. The dies fit snugly and produced clean 45-degree flares without visible leakage. The cone rolls smoothly and doesn’t scratch the tubing. Instructions were clear enough to follow without guesswork, and the clamp held the pipe securely during use. The cutter worked well on soft metal and PVC. The hard case has a clean layout and keeps the tools organized. The metal parts have a matte finish and look well-machined. For the range of sizes and included tools, it’s a good value for occasional or professional use.

Well made and did the job

Great tool easy to use. Gets the job done

Doesn't work too well with thin Chinese mini split cheap copper lines. I had to wrap the lines with electrical tape multiple times to make it kinda work, keeps pushing the lines out of the clamp. I hope the flares are big enough. Haven't tested them yet.

Great product, exactly as described. I definitely would buy again.

I purchased this a couple of months back as I had just ordered a new mini split system and needed to shorten the copper line set. The line said I was using was 5/8 by 3/8. For some reason, the 3/8 would not grip in the die so I had to wrap some electrical tape (2x wrapped) around it to grip. Not sure if this was the fault of the line set or the die itself being too large. In any case, I was able to create perfect eccentric, flares, and then just applied some dialogue before I tighten them down with the flare nuts. Overall I was very pleased with this set after I did a couple of test flares and figured out the trick to get it right PA- Attached is a photo of one of the test flares I did. I did not have the tube inserted far enough, so I ended up with the shallow flare, but as you can see, it is very smooth.

Mini spilt install worked well