YIHUA 858D

I have successfully replaced components with this station and it doesn’t take that long to heat up. Always proceed with caution my first attempt was 350 degrees and air level 3-3.5. Be very careful to not mold the plastic as that would need replacing it is a lot more efficient than a soldering iron as it is less room for error. Very good function

Does what it's meant to do. I used this to replace a usbc port on an nintendo switch, this was the first time I've done this and it was made easy by the cheap hot air station.

I use this far more than I expected to. It’s excellent. Does everything I need.

Nice piece of kit

Never been a great fan of heat guns, I prefer the trusty solder station. However, with advent of small surface mounted chips, together with a now shaky hand, I now need one. Looked at all the write ups, and took a punt on this one. It seems that you should start at a slightly lower temp, and increase it just enough to melt solder. This seems to keep the handle from getting too hot, and melting. Also, I don't think this is designed for extended work. It's more a hobby unit than professional, and for intermittent jobs. However, it works well if you don't overtax the thing. Update: also this thing works great for using heat-shrink tubing insulating electronic cable joints. As long as you set the temperature right down, and apply the heat just long enough to do the job.

great little item for the money have used it for quite a few job, gets to temperature fine, is decent build quality, dial is for fan speed, puttons control heat, you replace handheld part in carrage and fan keeps going to ensure device cools down safely.

Solid structure, good accessories, instructions are easy to follow and it worked well. Hopefully it will last.

It good it do what it sopose to do