XT60i to O Ring Terminal Cable，More Than 8A，10AWG Extension Cable XT60i Female to O Ring Connector XT60i-f Compatible with Lipo Batterie (1.5M/5FT)

Works well, high quality, will purchase again in near future!

I use this to charge /augment my ecoflow solar generator from a lithium iron phoshate battery !

I bought his to toy around with adding extra capacity to an Ecoflow unit without buying their 'extra battery' setup. I rigged up some LiFePO4 batteries and have this plugged into the solar connector for the Ecoflow all the time. When power goes off, this has reliably provided 'solar power' from the extra batteries I have setup close to the Ecoflow. It is a solid connection. I have never had an issue with it and when the power fails, it is always working. I like it.

Works well for using LiPo battery to double power station capacity. Has correct, and required, signal wire pre-installed.

Plain and simple everything was as advertised.

It was exactly the cable that I needed

I have a Delta 3 plus and Anker F3800, using 48 volt 100 amp rack batteries the Anker charges at 1100 watts. Delta 500 watts. If needed I can add another cable to double input. The XT60i fits both because the center pin is blank on Anker. Cost of rack batteries are far cheaper, with higher capacity than buying extra batteries. Be careful not to exceed max voltages to not let the magic smoke out

This cable worked quite well with my EcoFlow Delta 2. The cable is a good size and delivered 118 watts while I was charging from a battery. I also like the O ring better that another cable I have with claws. Did what it said it would do and I can't argue with that!!

Excellent produit, beaucoup plus efficace que des pinces. Supporte le 15 amp sans chauffe, souple et suffisamment long. J’utilise des batteries acide-plomb en 24 volts pour les jumelé à une Delta 3 plus. Cela me donne une plus grande autonomie pour ma maison. En 24 volts, la Delta 3 plus tire 345 watts des batteries externes (4 batteries x 6 volts). En 12 volts c’est 175 watts. Donc la Delta va prendre le max qu’elle peut soit 15 amp.

The cable is performing like a cigarette lighter input port 8V cable not as the as the advertised XT60i 3-pin cable to charge with O-rings off a service battery. My cable also seems to be defective even in the way it was assembled (connector is askew). I cannot get more than 102 watts to charge my Ecoflow Delta 2 generator therefore the same as the cigarette lighter cable. I will be returning.

I could only pull 100 w of my 12.8 volt lifepo4 battery to my ecoflow power station.