ELUTENG M.2 SATA NGFF to SATA Adapter (Not Support NVME/ M.2 PCIE) 6Gbps Dual NGFF MSATA B Key/ B&M Key SSD to 2.5" III Converter Adapter Max 4TB Support 2230 2242 2260 2280 SSDs

Works perfectly for M.2 SATA (not NVMe) — simple, sturdy adapter. Fits 2230/2242/2260/2280 B or B+M key SSDs, installs easily, and shows up as a regular 2.5" SATA drive. Got full SATA III speeds in my tests. Good build, affordable, great for reusing spare M.2 SATA modules. Simple and reliable.

It works as advertised, you can only access one drive at a time via the switch.

Skip this product, it fails to include the enclosure cover. Also, it will not work with two NGFF Sata drives combined. It has a switch on the board that allows the user to select NGFF #1 or #2 but there is no combined selection. Many other have also posted the product does not enclosure cover. Without the cover the NGFF drives will overheat as there is no heatsync (ie cover) to dissapate the heat resulting in premature NGFF drive failures.

This is a nice little board however, there is not much information about it's operation. After receiving, I can tell you that it does not have any side mounting holes, so you would have to mount to a drive kit. Also, there is a little switch at the top, that switches between the NVME's installed. You do not see both NVME's at the same time. It would be good to use as a flash drive if it was a USB interface instead of a SATA interface.

Cheapest working solution for me. I purchased 2 adapters for the four sata nvme I had. This setup gives me access to 1tb of storage with another 1tb on a switch. Transfer speeds are to be expected of the storage interface and the USB protocol. It cost me roughly 15 dollars to utilize 2tb of storage I had laying about, YMMV.

I'm torn on this one. The item was not as advertised. It does not have a case/enclosure as pictured. It would be one thing if it says in the description "case/backplate not included," but it doesn't even mention it! HOWEVER, for my use case this isn't a big deal as I can 3d print an enclosure. I will update this review shortly when I have a chance to test the adapter, my rating my change. ALSO, when is finish my case design I will share the file here so anyone else can grab the design and 3d print their own enclosure/backplate :) Stay tuned, this should take me less than one week to complete the design.

works great

Great adapter, plug and play. Easy to install and use and a great value.