13-5047 Tm Flat Slide Carburetor 28Mm

Used this carburetor on the 3 inch stroker mini bike build. The 28MM carb works very well on the 263cc. Very easy to tune and great throttle response. YouTube BLACK66

this is a genuine product as advertised, however my only complaint is no formal mikuni box, no instructions or stickers (pretty big on aftermarket stickers). just a box with the carb wrapped in brown paper. shipping was pretty good, no problems. cant wait to get everything I need to set it up :-D

Good carburetor, just wish it came packaged better and with mikuni stickers.

Bought this for my zs190. Couldn't be happier with the results. Throttle is very responsive and it runs beautifully. Yes its def fast as well.

I bought as an upgrade for my 1976 Yamaha DT 175, it installed without much modification, I had to remove the exhaust pipe, heat it with a torch and hammer it a bit, it's a bit larger than the VM26 round slide I replaced. Power and throttle response were significantly improved with this once I had it setup right. Your pilot jetting will be close to the VM if doing a replacement.

Works good but if you are using a fuel pump you need a fuel pump seat

Good carburetors, but be aware that the OD is 33mm NOT 35mm as advertised. This means the necessary addition of two 1mm shim rings that cost $20 each that are pressed onto the carb spigot. Then, you should install the rings with red locktite sealant, so they do not have any air leak at the ring. At second thought, I would have purchased the OKO or Keihin 28mm carbs and tried them out. Or, purchased 30mm TM30 Mikuni carbs and new manifolds. Be aware of the 33mm OD!

Right carb. Just having issues with tuning.