BELWITH Products 1027 Double Strike, 5-1/2-6, Polished Brass

I bought one for front and back. Adds extra security to a wood door frame. Easy to install if you've got a drill/driver, those 3 1/2" screws are the only hard part of the installation. Take off the old strike plates and position the new plate, test the door carefully then put a front center screw to hold it. (the three front holes are for the small screws, 1 1/2") The long screws go in the back 6 holes and you should test the door as you go. Pre-drill these first, and you're done. I put one 3 1/2" screw in each hinge for the same reason, (replace one existing screw in each hinge into the door frame).

The strike plate was a perfect fix for the door frame. The plate was shipped with nine 4 inch screws. I replaced them with 6 inch screws, because I wanted them to pass through the door frame and both 2x4 framing the door. The strike plate is very thick and well made. Even using an impact wrench the plate does not deform under the pressure. The landing lips are extra large and the lower bolt does not get stuck. The door closes with ease.

This plate does its job as expected. The only problem I encountered when installing it was that one of the mounting screws snapped off while being driven - despite having a pilot hole. Since the screw wasn't being driven "vigorously" at the time, nor at any odd angle, I have to assume that it was just brittle. Unfortunately, that could not be removed to allow use of a new screw, so the holding strength of the plate is reduced since it lacks one screw.

The material is thick and sturdy. Comes with 9 screws, 6 long 3 short. Big improvement on security vs. the standard strike plates that come with most locks.

Product had been opened and taped shut. I expected to see 6 long screws and 3 short screws. Why did I expect 9 screws............reading the reviews it stated there was 9 screws. Unless we are showing reviews for something other then the item I purchased. Upon installation I had trouble getting it properly positioned. I finally determine the stop bar for each open was bent. The most likely happen during shipping due to the fact the product had been open and taped shut poorly! I had to bend/adjust the stop bars to get it positioned correctly.

In our area, kicked-in doors are a common entry point for thieves. It's quite surprising how easy it is to kick in your average front or side door. These are nice quality, went in easily, and added some major strength to the construction. It's not the only thing you need to do to protect yourself, but it's a first step.

After 2 screws broke off in the pilot holes, had to extend the mortise, move the plate & go out to buy good screws.

The product is exactly what I expected. The screws are long enough to get a secure bite. I was shocked when I check the my door security of the locks to find that the contractor had only put in 1/2 screws one of which was not ever secure as I was able to pull it out of the door lock. While there is no sure fire way to protect your home, this product is a good start.