XT60 PDB with Dual BEC 5V/12V, Supports 3S-6S LiPo, 4-Layer 2oz Copper Power Distribution Board for FPV Drone RC (XT60 Soldering Required)

Description

This XT60 power distribution board (PDB) is built for FPV and RC builds, distributing LiPo power to up to 6 ESCs while providing regulated 5V and 12V outputs for flight controllers, receivers, cameras, VTX, LEDs, and more. The 4-layer PCB separates high-current motor paths from BEC circuits to reduce ground noise, and 2oz copper supports high current capacity. Package includes:1 × Power Distribution Board (supports 3S–6S batteries)1 × XT60 connector (user soldering/installation required)Key Specifications:Battery input support: 3S–6S LiPo (3S/4S/5S/6S)Copper: 2oz copper foil for high current handlingPCB: 4-layer design to reduce interference between motor current and BEC groundESC pads: 6 pairs of ESC power solder pads (fits X-frame / H-frame layouts)Dual BEC outputs: 5V / 3A synchronous rectifier switching BEC12V / 0.5A linear BEC (ultra-low ripple to help avoid image/video interference)Current rating: 4×25A continuous, 4×30A peak (10s)5V ripple: 40mV (Vin=16V, Vout=5V @ 2A load)Size: 52 × 36 × 3 mmWeight (incl. XT60): 11 gMounting holes: 30.5 mm spacing, 3 mm diameterFrame fit: upper board width <48 mmWarnings / Notes:Observe correct polarity; reverse polarity is strictly prohibited.Do not let the board backside contact carbon fiber plates to avoid short circuits; use insulation.With a 4S battery, the 12V output can supply 500mA continuously (±2.5% regulation).The 12V BEC can power one 12V camera + one 600mW VTX simultaneously.